Burst the washing machine tank? This is also possible, despite the fact that the washing takes place in the drum. Foreign objects entering the machine can seriously damage the plastic walls; moreover, bearings that are not replaced on time can affect wear. How to be and whether it is possible to independently restore the element of SMA
Bones from a bra, keys, rings and other foreign objects often fall into the opening of the heater. It is enough for a small element to rest against the heater, as the drum will scroll and push the part through the wall of the tank. All this happens quickly and under pressure, so the same ring can easily break through plastic.
If the tank breaks, no glue will help to fasten its parts, do not even hope. But still, even the repair of the non-separable tank “Indesit” and “Ariston” can be carried out with their own hands. To do this, disassemble the washer, saw two parts of the tank. For collapsible halves, it is enough to unscrew the screws around the perimeter. Remove the drum and crosspiece.
Attach the flying fragment to its original place.
Fasten the parts with a soldering iron.
If you have not found all the fragments, then cut a piece from the plastic casing.
The plot again became whole.
Also go soldering iron along the inner seams.
But this is not enough for normal functioning. Strong vibration and high heat preclude the use of glue. And soldered particles additionally need to be fixed with reinforcement. Lay the wire and also fasten it with a soldering iron.
Gradually cover the entire seam with wire, and remove excess parts with wire cutters.
Once the entire surface is covered, treat it with a soldering iron.
So you can glue the tank with your own hands. The reinforced part is not afraid of vibration and temperature changes. Repeat the same procedure from the inside.
Need more confirmation? Then watch the video Oleg Belokurov pouring the repaired tank with hot water. Check the quality of the work on the link: